StudX писал(а):Смущают слова о единственно правильной и о достоинстве мониторов установленных в нишу.
Неужели все остальные студии в Беларуси имеют неправильную контрольную комнату?
Мониторы в нише это достоинство или недостаток?
Вот, что рекомендует уважаемая фирма Genelec (цитата отсюда -
http://www.genelec.com/faq/acoustical/f ... -monitors/):
Is flush-mounting monitors a good idea?
ALL monitors that are traditional 'square box type' designs benefit from flush-mounting for the following reasons:
Edge diffraction is eliminated so the midrange is smoother
Eliminates the cancellation reflection from the wall behind the monitor
Acoustical loading is increased so the monitor does not have to work so hard at low frequencies
The following should be considered when flush-mounting any monitor:
For the benefits listed above the wall construction should be solid and consisting of heavy mass material. However this can lead to reverberation time problems at low frequencies
If the wall is totally solid and reflective then some lower midrange boost may occur, so make the wall slightly absorptive around the 200 to 500 Hz region - use 10 to 20 cm thick rock wool or foam plastic glued onto the front wall surface
Amplifier cooling, possibly forced air-cooling, should be sufficient if the amplifier is not separately rack mounted (rack-mount kits are available for the 1032A, (S30D - discontinued), 1037C and 1038B)
The monitor's acoustical tone controls must support the change in acoustical loading presented by the hard wall where the monitors are flush mounted and which implements then an ‘infinite baffle’ load. If these adjustments are not done, then a flat frequency response may not be achieved.
The flush mounting details around the enclosure should be as smooth as possible; otherwise the cabinet edge diffraction benefits will be wasted.
А про правильность я сказал потому, что не знаю в Беларуси студий, в которых контрольная комната строилась по рассчитаным геометрическим пропорциям, использовалась многослойная система поглощения, выполненная из материалов с различными плотностями и коэффициентами поглощения. Параметры системы поглощения расчитывались специально, исходя из геометрических пропорций комнаты.
При проектировании и строительсте студии нам помогали консультациями господин Кравченко и специалисты по акустике из фирмы Waves.